Cisco BTS 10200 Softswitch Manual page 99

Chapter 1 Digit Translations
EARLY_BKWD_
MSG_TMR
GLARE
H323_GW_ID
ID
OL-8001-10
Automatic Number Identification/Dialed Number Identification Service Manipulation
Description: Specifies the amount of time, in seconds, for the Early
Backward Message timer. Applies only if send-early-bkwd-msg=Y.
INTEGER: 0-30 (Default = 5).
Valid for Command: add, change, audit, sync, show
Default Value: 5
Possible Value: [0_30]
Parser: DecimalParser
Description: Used in bothway trunks. Defines how to resolve a glare
condition—a bothway (simultaneous) trunk seizure. For example, an
incoming and an outgoing call on the same endpoint.
For ISDN trunk groups, glare must be set to ALL. Setting glare to SLAVE
can cause CIC/trunk instability.
VARCHAR(5): 1-5 ASCII characters. Permitted values are:
SLAVE (Default)—This trunk group yields any trunk in glare condition.
ALL—This trunk group is master of all trunks.
EVEN—This trunk group is master of even numbered trunks.
ODD—This trunk group is master of odd numbered trunks.
PC—Not used. Point code driven. In the absence of an overriding control
assignment (such as all or none), the SPCS with the higher assigned
signaling point code controls the even numbered circuits, and the SPCS with
the lower signaling point code controls the odd-numbered circuits.
Valid for Command: add, change, audit, sync, show
Default Value: SLAVE
Possible Value: ALL, SLAVE, ODD, EVEN, PC
Parser: TextParser
Description: Mandatory if tg-type=h323. Foreign key: H.323 Gateway table.
Specifies the gateway id for this trunk group.
VARCHAR(16): 1-16 ASCII characters.
Valid for Command: add, change, audit, sync, show
Possible Value: [1_16]
Parser: TextParser
Description: Primary key. Trunk group number.
INTEGER: 1-99999999.
Valid for Command: add, change, show, delete, audit, sync, control, status
Mandatory: add, change, delete, control, status
Possible Value: [1_99999999]
Parser: DecimalParser
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
1-83