Chapter 3
Dial Plans and Routing
Tandem Provisioning
This section provides general information on tandem provisioning. The following topics are discussed:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Automatic Number Identification
The ANI table is used for the ANI screening feature. The table keeps track of allowed/blocked status
ANI. If the ANI status is blocked, the call is not allowed.
Automatic Number Identification Screening
The ANI Screening (ani-screening) table performs ANI screening on calls received over a trunk group.
Normally, ANI screening is performed on calls received from a PBX (ISDN, H.323, and Session
Initiation Protocol (SIP)). This table allows performing ANI-based routing in addition to ANI screening.
When a record is found that matches the incoming ANI, the subscriber ID associated with the record is
used for further digit analysis and routing.
Automatic Number Identification Screening Profile
The ANI Screening Profile (ani-screening-profile) table defines an id to perform ANI screening. The ID
is assigned to a trunk group when ANI screening is required or when ANI-based routing is required for
calls originating over a trunk group.
OL-8001-10
Automatic Number Identification
Automatic Number Identification Screening
Automatic Number Identification Screening Profile
Cause Code Map
Cause Code Map Profile
H.323 Gateway
H.323 Gateway to Gatekeeper
H.323 Terminal
H.323 Terminal Profile
H.323 Trunk Group Profile
II White Black List
Service Provider
Technical Prefix Group Profile
Technical Prefix Group
Trunk Group Feature Data
Trunk Group Service Profile
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Tandem Provisioning
3-17