Table Of Contents; Update To Command Reference - Cisco 11.0 BT Release Notes

Update to Command Reference

The information that follows is an update to the Router Products Command Reference, Chapters 23
to 33. Add the TN3270 information as a standalone chapter following page 33-30.
TN3270 Server Commands
This update describes the commands to configure TN3270 support on the Channel Interface
Processor (CIP). For TN3270 configuration tasks and examples, refer to the "Configuring TN3270
Server on the Channel Interface Processor" update chapter of this Release Note.
The following commands are documented in this update chapter:
•
dlur, page 20
•
dlus-backup, page 21
•
generic-pool, page 22
•
idle-time, page 24
•
keepalive, page 25
•
link, page 26
•
lsap, page 28
•
maximum-lus, page 30
•
preferred-nnserver, page 31
•
pu (DLUR), page 35
•
pu (direct), page 32
•
show extended channel tn3270-server, page 36
•
show extended channel tn3270-server client-ip-address, page 39
•
show extended channel tn3270-server dlur, page 42
•
show extended channel tn3270-server dlurlink, page 44
•
show extended channel tn3270-server pu, page 45
•
show extended channel tn3270-server pu lu, page 48
•
shutdown, page 51
•
tcp-port, page 52
•
tn3270-server, page 54
•
timing-mark, page 53
•
unbind-action, page 55
•
vrn, page 56
Update to Command Reference
TN3270 Server Commands 19