Cisco 11.0 BT Release Notes page 10

TN3270 Configuration Modes
After the VTAM activation, the server can support session requests from clients using dynamic or
specific LU allocation.
TN3270 Configuration Modes
The TN3270 configuration modes and router command prompts are described in the following
sections and displayed in Figure 3. The TN3270 server can be configured only on Port 2, the internal
LAN port, of a CIP card.
Some configuration commands create entities on the CIP. For most of these, the command changes
to the mode associated with that entity (for example, a PU). In general, the parameters provided to
create the entity come in two sets: those which identify the specific instance of the entity (for
example, a PU name) and those that merely set operating parameters. To return to the mode later, the
same command is used but with only the first set of parameters. The following example tasks clarify
how to return to a command mode without necessarily creating a new entity:
To create a DLUR LSAP and enter DLUR LSAP configuration mode, perform the following task
beginning in TN3270 DLUR configuration mode:
Task
Create a DLUR LSAP and enter DLUR LSAP
configuration mode.
To return later to the DLUR LSAP configuration mode on the same entity, perform the following
task beginning in TN3270 DLUR configuration mode:
Task
Enter DLUR LSAP configuration mode on the
same LSAP.
To remove an entity, the same identification parameters are needed. Perform the following task
beginning in TN3270 DLUR configuration mode:
Task
Remove a previously defined DLUR LSAP entity.
TN3270 configuration modes described in this section include the following:
•
•
•
•
•
10 Configuring TN3270 Server on the Channel Interface Processor
TN3270 Server Configuration Mode
DLUR Configuration Mode
DLUR SAP Configuration Mode
PU Configuration Mode
Commands Allowed in Multiple Modes
Command
lsap token-adapter 1 84
Command
lsap token-adapter 1
Command
no lsap token-adapter 1