Generic-Pool - Cisco 11.0 BT Release Notes

generic-pool

generic-pool
Use the generic-pool TN3270 configuration command to specify whether or not left over LUs will
be made available to TN3270 sessions that do not request a specific LU or LU pool through
TN3270E. Use the no form of this command to selectively remove the permit or deny condition of
generic pool use.
Syntax Description
permit
deny
Defaults
In TN3270 configuration mode, generic pool use is permitted.
In PU configuration mode, the default is the value currently configured in TN3270 configuration
mode.
Command Modes
TN3270 configuration
PU configuration
Usage Guidelines
A left over LU is defined as one for which all of the following conditions are true:
•
•
All LUs in the generic pool are, by definition, DDDLU capable.
Values entered for generic-pool in TN3270 configuration mode apply to all PUs for that TN3270
server but can be changed in PU configuration mode.
In PU configuration mode, a no generic-pool command will restore the generic-pool value entered
in TN3270 command mode.
In TN3270 configuration mode, the no generic-pool command reverts to the default, which permits
generic pool use.
The command takes effect immediately. If generic-pool deny is specified on a PU, no further
dynamic connections to it will be allowed. Existing sessions are unaffected, but, as they terminate,
the LUs will not become available for dynamic connections.
22 TN3270 Server Commands
generic-pool {permit | deny}
no generic-pool
The system services control point (SSCP) did not send an ACTLU during PU start up; and
The PU controlling the LU is capable of carrying product set ID (PSID) vectors on network
management vector transport (NMVT) messages, thus allowing dynamic definition of dependent
LU (DDDLU) operation for that LU.
Left over LUs should be made available to TN3270 users
wanting generic sessions. This value is the default.
Left over LUs should not be given to a generic pool. The
physical unit (PU) is not automatically fully populated with
255 LOCADDR definitions. The default is the value
configured in TN3270 configuration mode.