Cisco 11.0 BT Release Notes page 15

Task
(Optional) Specify the idle time for server
disconnect. This command is also available in
TN3270 configuration mode.
(Optional) Specify the maximum time allowed
between keepalive marks before the server
disconnects. This command is also available in
TN3270 configuration mode.
(Optional) Specify whether the TN3270 session
will disconnect when an UNBIND command is
received. This command is also available in
TN3270 configuration mode.
(Optional) Select whether "left-over" LUs can be
used from a generic LU pool. This command is also
available in TN3270 configuration mode.
When you use the pu command, you enter PU configuration mode and can use all other commands
in this task list. Configuration values you enter in PU configuration mode will override other values
entered while in TN3270 configuration mode. In addition, you can enter PU configuration mode
from DLUR configuration mode when configuring PUs that are connected by means of DLUR.
If you are configuring PUs for directly connected hosts, you need not perform any additional
configuration tasks.
Configure DLUR
This task is required when configuring DLUR connected hosts. To configure DLUR parameters for
the TN3270 server, perform the following tasks beginning in TN3270 configuration mode.
Task
Create a DLUR function in the TN3270 server and
enter DLUR configuration mode.
(Optional) Specify the fallback choice for the
DLUR DLUS.
(Optional) Specify the preferred network node
(NN) server.
Configure SAPs under DLUR
To configure SAPs under the DLUR function, perform the following tasks beginning in DLUR
configuration mode.
Task
Create a SAP function under DLUR and enter
DLUR SAP configuration mode.
(Optional) Identify an APPN virtual routing node
(VRN).
Command
idle-time num-of-seconds
keepalive num-of-seconds
unbind-action {keep | disconnect}
generic-pool {permit | deny}
Command
dlur fq-cpname fq-dlusname
dlus-backup dlusname2
preferred-nnserver NNserver
Command
lsap type adapno [lsap]
vrn vrn-name
Configuring TN3270 Server on the Channel Interface Processor
TN3270 Configuration Task List
15