Removing The Battery; Installing The Battery - Husqvarna FE 350 2014 Repair Manual

15
WIRING HARNESS, BATTERY
Removin the batte
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
-
Keep batteries out of the reach of children.
-
Wear suitable protective clothing and goggles.
-
Avoid contact with battery acid and battery gases.
-
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
-
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at
least 15 minutes and contact a physician.
Preparatory work
-
Switch off all power consumers and switch off the engine.
-
Remove the seat. ( p. 76)
.-
Main work
-
Pull back the negative terminal cover
the battery.
-
Pull back the positive terminal cover
the battery.
8
Detach rubber band
-
Lift the battery up and out.
Main work
-
Insert battery into the battery compartment with the terminals facing to the front.
I
Battery (YTX5L-BS) ( .-
-
Reconnect rubber band
• Info e
I
Contact disk
0
socket with the claws facing down.
-
Position the positive cable and mount and tighten the screw.
Guideline
Screw, battery terminal
-
Slide positive terminal cover
-
Position the negative cable and mount and tighten the screw.
Guideline
Screw, battery terminal
-
Slide negative terminal cover
Finishing work
-
Mount the seat. ( .- p. 76)
O
and disconnect the negative cable from
8
and disconnect the positive cable from
at the bottom.
p. 204)
O.
must be mounted between screw
M5
8
over the positive terminal.
M5
8
over the negative terminal.
102
e
and cable
2.5 Nm
(1.84 lbf ft)
2.5 Nm
(1.84 lbf ft)