Checking The Crankshaft Run-Out At The Bearing Pin; Measuring The Crankshaft End Play; Removing The Drive Wheel Of The Balancer Shaft - Husqvarna FE 350 2014 Repair Manual

ENGINE
18
18.4.9

Checking the crankshaft run-out at the bearing pin

18.4.10

Measuring the crankshaft end play

18.4.11

Removing the drive wheel of the balancer shaft

-
Position the crankshaft on a roller block.
-
Turn the crankshaft slowly.
Check the crankshaft run-out on both bearing pins.
I
Crankshaft - run-out at bearing pin
If the crankshaft run-out at the bearing pin is larger than the specification:
-
Align the crankshaft.
-
Insert the crankshaft into the right section of the engine case.
• Info
I
Do not forget the fitted bushings.
-
Mount the left section of the engine case.
-
Mount and tighten the screws.
I Guideline
Screw, engine case
-
Mount the dial gauge support on the engine case and measure and note down
the crankshaft end play.
I
Guideline
Crankshaft - axial play
If the measured value does not meet specifications:
-
Remove the crankshaft.
-
Remove the crankshaft bearing inner race.(..- p. 147)
-
Calculate the thickness of the compensating disks.
-
Add or remove compensating disks equally on both sides.
Info
•
I
If the end play is too small, remove compensating disks.
If the end play is too large, add compensating disks.
-
Install the crankshaft bearing inner race.(..- p. 147)
-
Position the balancer shaft in the press with special tool
I
Separator plate (77229032000) (..- p. 264)
8.
-
Mount special tool
I
Protection cap (77229031000) (..- p. 264)
-
Press out the drive wheel of the balancer shaft.
I
:5 0.03 mm (:5 0.0012 in)
I I
M6 10 Nm (7.4 lbf ft)
I
0.50 ... 0.60 mm (0.0197 ... 0.0236 in)
O.
149