Checking The Routing Of The Throttle Cable - Husqvarna FE 350 2014 Repair Manual

HANDLEBAR,CONTROLS
7
7.4
Checkin the routing of the throttle cable
7.5
Preparatory work
-
Remove the seat. (.- p. 76)
-
Remove the fuel tank. (.- p. 76)
Main work
-
Check the routing of the throttle cable.
Both throttle cables must be routed to the throttle valve body side by side
behind the handlebars and above the fuel tank bearing.
If the throttle cable is not routed as specified:
-
Correct the routing of the throttle cable.
Finishing work
-
Install the fuel tank. (.- p. 78)
-
Mount the seat. (.- p. 76)
-
Check the throttle grip for smooth operation.
-
Move the handlebar to the straight-ahead position. Move the throttle grip back
and forth slightly to ascertain play
I
Play in throttle cable
If the throttle cable play does not meet specifications:
-
Adjust the play in the throttle cable. (.- p. 40)
Danger
Danger of poisoning
result in unconsciousness and/or death.
-
When running the engine, always make sure there is sufficient ventila­
tion, and do not start or run the engine in an enclosed space without
an effective exhaust extraction system.
-
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
I
The idle speed must not change.
If the idle speed changes:
-
Adjust the play in the throttle cable. (.- p. 40)
6)
in the throttle cable.
13 ...
5 mm (0.12 ... 0.2 in)
Exhaust gases are toxic and inhaling them may
39