6
FORK, TRIPLE CLAMP
Assembling the fork legs
Info
When assembling, ensure that the right cartridge is mounted in the corresponding inner tube and the right adjuster is
mounted on the corresponding screw cap.
Compression damping side - screw cap with mark
Rebound damping side - screw cap with mark REB, no brake caliper holder, red adjuster.
/
-8
-8
-
Position sleeve
-
Clamp the tube of the cartridge into a vise.
I
Clamping stand (T14049S) (- p. 269)
-
Slide reservoir
•
Info
I
Hold the sleeve in the reservoir to prevent it from sliding out.
Mount lock ring
-
Mount seal ring retainer @ with the washer and tighten.
Guideline
Seal ring retainer
-
Unclamp the cartridge.
-
Slide piston rod
•
Info
I
Ensure that the piston ring is seated correctly.
-
Mount spring seat
201797-10
-
Degrease piston rod
I
Clamping stand (T14049S) (- p. 269)
-
Screw spring guide Gi) all the way on.
Info
•
I
The nut must be firmly tightened against the stop by hand. Do not use a
tool.
-
Mount adjusting tube
-
Unclamp the piston rod. Mount the preload spacer(s).
Preparatory work
-
Assemble the hydrostop unit. (- p. 24)
Main work
-
Clamp the inner tube with the axle clamp.
e
Guideline
I
Use soft jaws.
-
Mount special tool.
I
Protecting sleeve (T1401) (- p. 268)
201714-10
8
in the reservoir.
0
onto the tube.
(D.
M23.5x0.75
fD
into the cartridge.
@).
fD
and clamp in the vise.
48.
COMP,
brake caliper holder, white adjuster.
46 Nm
Loctite
®
2701
(33.9 lbf ft)
27
TM