Checking The Cylinder Head; Installing The Valves - Husqvarna FE 350 2014 Repair Manual

Table of Contents

Advertisement

ENGINE
18
18.4.26

Checking the cylinder head

18.4.27

Installing the valves

-
Check valve guides
I
Limit plug gauge (77229026000) (or p. 264)
If the special tool is easy to insert in the valve guide:
-
Change the valve guide and valve.
-
Check the sealing area of the spark plug thread and the valve seats from damage
and cracking.
If there is damage or cracking:
-
Change the cylinder head.
302805-10
-
Using a straightedge and the special tool, check the sealing area of the cylinder
for distortion.
I
Feeler gauge (590290411 00) (or p. 261)
Cylinder/cylinder head - distortion of
sealing area
If the measured value does not meet specifications:
-
Change the cylinder head.
-
Check sealing seat
Valve - sealing seat width
Intake
Valve - sealing seat width
Exhaust
If the measured value does not meet specifications:
-
Rework the valve seat.
302808-10
-
Blow compressed air through all oil channels and check that they are clear.
-
Position valve spring seat
-
Mount the valve corresponding to its installation position.
-
Mount the valve spring with the tighter coil facing downward.
-
Mount the valve spring retainers.
302712-11
-
Pre-tension the valve spring using the special tool.
Valve spring mounter (59029019000) (or p. 261)
Insert for valve spring lever (77229060000) (or p. 265)
O
using the special tool.
:!> 0.10 mm (:!> 0.0039 in)
fj
of the valves.
1.40 mm (0.0551 in)
1 .40 mm (0.0551 in)
O.
Mount valve stem seal
156
8.

Advertisement

Table of Contents
loading

Table of Contents