Mounting The Cisco Unified Videoconferencing 3515 Mcu Unit In A 19-Inch Rack - Cisco MCU24 Installation And Upgrade Manual

Mounting the Cisco Unified Videoconferencing 3515 MCU Unit in a 19-inch Rack

Mounting the Cisco Unified Videoconferencing 3515 MCU Unit
in a 19-inch Rack
You can optionally mount the Cisco Unified Videoconferencing 3515 MCU unit in a standard 19-inch
rack. Two mounting brackets and a set of screws are included in the Cisco Unified
Videoconferencing 3515 MCU unit shipping box.
Procedure
Step 1 Disconnect all cables including the power cables.
Step 2 Place the Cisco Unified Videoconferencing 3515 MCU unit right-side up on a hard flat surface, with the
front panel facing you.
Step 3 Position a mounting bracket over the mounting holes on each side of the Cisco Unified
Videoconferencing 3515 MCU unit, as shown in
Figure 2-2
Pass the screws through the brackets and tighten them into the screw holes on each side of the
Step 4
Cisco Unified Videoconferencing 3515 MCU unit using a suitable screwdriver.
Insert the Cisco Unified Videoconferencing 3515 MCU unit into the 19-inch rack.
Step 5
Fasten the brackets to the side rails of the rack.
Step 6
Make sure that the air vents at the sides of the Cisco Unified Videoconferencing 3515 MCU unit are not
Step 7
blocked.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
2-4
Fitting a Bracket for Rack Mounting
Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU
Figure 2-2.
OL-11897-01