Setting The Ip Address - Cisco MCU24 Installation And Upgrade Manual

Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration

Setting the IP Address

This section describes how to use the serial port to configure the unit with an IP address and other
address information.
The upper serial port on the Cisco Unified Videoconferencing 3515 MCU
assign a new IP address to your Cisco Unified Videoconferencing 3515 MCU
IP address before or after you connect the hardware to the network.
Before You Begin
Gather the items listed in
Videoconferencing 3515 MCU unit.
Table 2-3
Requirements
Dedicated IP address for the Cisco Unified
Videoconferencing 3515 MCU unit
IP address of the default router the Cisco Unified
Videoconferencing 3515 MCU unit uses to
communicate over the network
Subnet mask for the Cisco Unified
Videoconferencing 3515 MCU unit if applicable
Domain Name Server and domain name for
Cisco Unified Videoconferencing 3515 MCU unit
if applicable
PC with available serial port and terminal
emulator software installed
RS-232 terminal cable (shipped with the unit)
Procedure
Connect the RS-232 terminal cable to the PC terminal.
Step 1
Connect the power cable.
Step 2
Start the terminal emulation application on the PC.
Step 3
Set the communication settings in the terminal emulation application on the PC as follows:
Step 4
Turn on the power to the Cisco Unified Videoconferencing 3515 MCU
Step 5
A log of the auto-boot events appears on the computer.
When the message "Press any key to start configuration" appears on the screen, press any key within six
Step 6
seconds.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
2-6
Table 2-3
Requirements for Setting the IP Address
Baud rate: 9600
–
Data bits: 8
–
– Parity: None
– Stop bits: 1
– Flow control: None
Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU
to assign an IP address to the Cisco Unified
Notes
front panel is used to
unit
. You can assign the
unit
.
unit
OL-11897-01