Table of Contents
Advertisement
Video Processing Module Initial Configuration for the 3515 MCU
Changing Advanced Configuration Settings
You can use the serial port to change the following advanced configuration settings:
•
•
•
•
Procedure
At the prompt, enter A to access the Advanced Configuration menu.
Step 1
The Advanced Configuration menu appears as follows:
At the prompt, enter 1 to configure the web server port.
Step 2
The current web port server setting displays.
At the prompt, enter 2 to restore the factory configuration settings.
Step 3
You are asked to confirm your choice as follows:
Step 4
Enter y or n.
Step 5
At the prompt, enter 3 to change Ethernet speed and duplex parameters.
The network interface card settings screen appears as follows:
Enter either a number between 0 and 5 inclusive, representing the required option.
Step 6
Press any other key to quit without changing the network working mode.
Step 7
At the prompt, enter 4 to disable the DSP reset facility.
Step 8
After options Q and 1-3, press any key to return to the video processing module Main menu. After option
Note
4, the video processing module Main menu displays automatically.
Caution
Only qualified technical personnel should modify the DSP reset function settings.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
2-12
Web server port (for future use)
Restore factory configuration (for future use)
LAN port settings
Disable DSP reset
Advanced configuration menu
Q: Quit
1: Configure web server port
2: Restore factory configuration
3: Change Lan port Settings
4: Disable DSP reset
Select:
Select: 2
Are you sure you want to restore factory configuration? [y, n]:
Choose : 1 - 10Mbps
: 2 - 100Mbps Half Duplex
: 3 - 10Mbps
: 4 - 100Mbps Full Duplex
: 5 - Auto
other - Quit
:
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
Half Duplex
Full Duplex
OL-11897-01
Advertisement
Table of Contents
