Preparing To Install The 3515 Mcu - Cisco MCU24 Installation And Upgrade Manual

Preparing to Install the 3515 MCU

Figure 2-1
describes the components of the front panel.
Figure 2-1
Table 2-1
Component
10/100 BaseT connector An RJ-45 connector that provides the primary Ethernet connection for the IP
Serial connector
RST button
GK Reg and MC LEDs
CPU High LED
ACT LED
ALARM LED
10/100 BaseT LEDs

Preparing to Install the 3515 MCU

This section describes the installation requirements for installing the Cisco Unified
Videoconferencing 3515 MCU unit.
•
•
•
•
•
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
2-2
shows the front panel of the Cisco Unified Videoconferencing 3515 MCU unit.
Cisco Unified Videoconferencing 3515 MCU Front Panel
10/100 Base T
10/100 Base T
Front Panel Components
Description
network port.
A DB-9 connector that allows you to connect a PC terminal for local
configuration.
Allows you to reset the Cisco Unified Videoconferencing 3515 MCU unit
manually.
Lights green when the Cisco Unified Videoconferencing 3515 MCU unit is
registered with a gatekeeper.
Lights green when more than 50% of the Cisco Unified
Videoconferencing 3515 MCU unit resources are in use.
Lights green to indicate that there is at least one currently active conference
on the Cisco Unified Videoconferencing 3515 MCU unit.
Lights green to indicate that an error has occurred and the Cisco Unified
Videoconferencing 3515 MCU unit requires resetting.
The top part of the 10/100 BaseT connector contains two LED indicators.
The left-hand LED lights green when the local IP network link is active. The
right-hand LED lights green if the connection speed is 100 Mbps, and is off
when the connection speed is 10 Mbps.
Proper clearance at the sides of the unit to allow adequate ventilation, and at least 20 cm clearance
at the back of the unit to allow access to cable connections
A PC with a serial port and terminal emulation software to assign the Cisco Unified
Videoconferencing 3515 MCU unit an IP address
Two dedicated IP addresses—one each for the MCU and EMP units
The IP address of the router that the Cisco Unified Videoconferencing 3515 MCU unit will use to
communicate across the network
For an H.323 environment, IP address of the H.323 gatekeeper with which you want the
Cisco Unified Videoconferencing 3515 MCU unit to register
Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU
GK Reg CPU Hight
SERIAL
RST ALARM ACT
MC CPU Hight
SERIAL
RST ALARM ACT
Table 2-1
PWR
OL-11897-01