Installing The Universal Port Dfc - Cisco AS5400 Installation Manual

Chapter 5 Universal Port Dial Feature Card
Router# show chassis slot 3
Slot 3:
DFC type is NP108 DFC
OIR events:
DFC State is DFC_S_OPERATIONAL

Installing the Universal Port DFC

Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. To
see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information document that accompanied this device.
Note When you replace a DFC with a new DFC of the same type in the same slot, the system software will
recognize the new trunk interfaces and bring them up automatically. If you replace the existing DFC
with a new DFC of a different type, you will have to reconfigure the system. For configuration details,
refer to the Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide.
To install the universal port DFC, follow these steps:
Attach an ESD preventive wrist strap.
Step 1
Slide the DFC into the slot until the connector pins make contact with the carrier card backplane
Step 2
connector. (See
Figure 5-9
Figure 5-10 Install the Universal Port DFC in the Cisco AS5400
Align the captive screws with their holes, and then seat the card completely.
Step 3
78-13311-01
Number of insertions = 1, Number of removals = 1
Figure 5-9 and Figure
Install the Universal Port DFC in the Cisco AS5350
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
Online Insertion and Removal (OIR) of the Universal Port DFC
5-10.)
5-7