Cisco AS5400 Installation Manual page 28

Overview
Figure 3-2
Figure 3-3
Table 3-1
Description
Line rate
Data rates (per port) number x 56 or number x 64 kbps, where
Standards
Input impedance
Table 3-2
Description
Line rate
Data rate (per port) number x 56 or number x 64 kbps, where number = 1 to 31.
Input impedance
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
3-2
4-Port T1 or E1 DFC
Bantam ports
T1 or E1 ports
0
1
2
3 Rx
Tx
8-Port T1 or E1 DFC
T1 DFC Network Specifications
Specification
1.544 Mbps
number = 1 to 24
AT&T Pub. 62411, 54016, and 43081,
and ANSI T1.403
100 ohms per port
E1 DFC Network Specifications
Specification
2.048 Mbps
75 or 120 ohms per port
The factory default setting for the E1 ports is 120 ohm. Use a software
Note
command to change the impedance. Refer to the, Cisco AS5350 and
Cisco AS5400 Universal Gateway Card Installation Guide.
4 PRI
ACT
OK/
MAIN T
Chapter 3 T1 and E1 Dial Feature Cards
78-13311-01