Cisco AS5400 Installation Manual page 51

Chapter 5 Universal Port Dial Feature Card
Figure 5-3
Step 2 Initialize the software busyout procedure by entering the busyout command:
Router# busyout
Enter the show busyout command to check busyout status for that specific slot:
Step 3
Router# show busyout
You may use the clear port command to immediately disable active calls on the universal port card.
Step 4
Router# clear port
Verify that the OIR/MAINT LED is off; this indicates that the DFC is offline and ready to be removed.
Step 5
Note
Attach an ESD-preventive wrist strap.
Step 6
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. To
see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information document that accompanied this device.
Disconnect all interface cables from the DFC.
Step 7
78-13311-01
Slot Numbering on the Cisco AS5400 Chassis
Slot 0 Slot 1
Slot 2 Slot 3
Slot 4
Slot 6
slot-number
slot-number
slot-number/port number
The OK/MAINT LED is green before you enter the busyout command. After you enter the
busyout command, the LED changes to yellow. The LED turns off after all calls are
disconnected and resources taken out of service, indicating that busyout is complete.
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
Online Insertion and Removal (OIR) of the Universal Port DFC
Slot 5
Slot 7
5-3