Cisco AS5400 Installation Manual page 46

Online Installation and Removal (OIR) of the T3 DFC
To install the T3 DFC, follow these steps:
Step 1 Attach an ESD-preventive wrist strap.
Step 2 Slide the DFC into the slot until the connector pins make contact with the carrier card backplane
connector. (See
Figure 4-9
Figure 4-10 Install the T3 DFC in the Cisco AS5400
Align the captive screws with their holes, and seat the card completely.
Step 3
Tighten the screws to secure the DFC to the chassis. (See
Step 4
Figure 4-11 Tighten the Captive Screws on the Cisco AS5350
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
4-6
Figure 4-9 and Figure
Install the T3 DFC in the Cisco AS5350
Captive
DFC
Captive
screw
screw
4-10.)
Figure 4-11
Carrier
card
Chapter 4 T3 Dial Feature Card
and Figure 4-12.)
Chassis
78-13311-01