Cisco AS5400 Installation Manual page 53

Chapter 5 Universal Port Dial Feature Card
Figure 5-7
Avoid touching any pins or circuit board components during removal and installation of a DFC.
Caution
After you remove the DFC, set it aside on an ESD-preventive mat.
Step 10
If the DFC slot is to remain empty, install a blank cover over the open DFC slot to ensure proper airflow
Step 11
inside the chassis. (See
Figure 5-8
The following output is an example of online insertion and removal of a universal port DFC in slot 3:
Router# show chassis slot 3
Slot 3:
DFC type is NP108 DFC
OIR events:
DFC State is DFC_S_OPERATIONAL
Router#
Router# show busyout 3
Slot 3 is not being busied out
Router#
Router# busyout 3
Busyout in progress for 3
Router#
Router# show busyout 3
Slot busyout is in progress
Slot 3:Pending (64 calls remaining)
Router#
Router# show chassis slot 3
Slot 3:
DFC type is NP108 DFC
OIR events:
DFC State is DFC_S_OPERATIONAL
78-13311-01
Remove the DFC from the Cisco AS5400
Figure 5-8.)
Blank DFC Cover
Number of insertions = 0, Number of removals = 0
Number of insertions = 0, Number of removals = 0
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
Online Insertion and Removal (OIR) of the Universal Port DFC
5-5