Notification And Error Indication; Canceling A Notification And Error Indication; Notification Of A Need Of Care, Etc; Error Notification - Makita DRC300 Instruction Manual

Notification and Error Indication

When care is required or an error occurs, a red lamp lights up on the operation panel of the robotic cleaner, with the error number displayed. In addition, there can be a
notification with a sound.

Canceling a notification and error indication

• When a notification for filter care appears, the robotic cleaner can be operated but may not work properly. Remove the cause before using the robotic cleaner.
• When an error notification appears, the robotic cleaner stops operating. Take action as follows.
1. Check the error number and remove the cause of the error. (See "Notification of a need of care, etc." on this page.)
• If you turn off the power or the power runs out due to loss of the battery capacity before removal of the error cause, the robotic cleaner cancels the error temporarily.
2. Pressing the start/stop button of the robotic cleaner or the remote control cancels the error indication, and the robotic cleaner enters the stand -by state.
3. Check that the error is cleared before using the robotic cleaner.
NOTICE
• Restart the robotic cleaner if you cannot operate the robotic cleaner after removing the cause.
• If the same error appears repeatedly, ask the shop from which you made a purchase or our sales office to do repair.

Notification of a need of care, etc.

If the lamp lights up, turn off the power and remove the batteries. Then, take action as described below.
Notified problem
• Filter care is necessary.

Error notification

• Take action according to the error lamp and number on the indicator.
• For the error codes in the list, a specific number will be displayed in place of the "X" depending on the error type. Report the error code when contacting the dealer or our
sales office.
• When you check the cause or take action, turn off the power and remove the batteries as necessary before taking action.
• If an error number other than those listed below is displayed, ask the shop from which you made a purchase or our sales office.
Number
Notified problem
E01X
Error of drive wheels
E02X
Error due to loss of a
wheel or uplift of the
robotic cleaner
E030
Error of the main brush
Cause
Dust is accumulated or the filter is clogged.
Cause
Is foreign matter such as lint or hair caught in the drive wheels?
When the robotic cleaner goes through a low gap, the robotic
cleaner may get caught in the gap, displaying this notification.
Is a drive wheel derailed, or is a wheel separated from the
ground?
Is foreign matter such as lint or hair caught in the main brush?
28
Discard the dust and care for the filter.
See pages 21 and 24.
Check to see if dust is accumulated inside the robotic cleaner
and at the exhaust opening.
Remove foreign matter.
See page 26.
It is not failure.
Move the robotic cleaner to another place.
See page 10.
Remove foreign matter.
See page 25.
ENGLISH
Action
Action