Adding Mapping Information Manually (Manual Mapping); Changing The Name Of Mapping Information - Makita DRC300 Instruction Manual

• Tapping on [Pause] results in the robotic cleaner stopping mapping
temporarily.
• Tapping on [Go to Home] while paused results in the robotic cleaner going
back to the point where it started mapping. The mapping information created
up to when you tapped is registered. As the robotic cleaner goes back to the
starting point, the app goes to the home screen.
7. After the mapping is completed, the dialogue whether to perform area settings
is displayed.
• If you want to limit the range of cleaning, tap on [Go to Area Settings]. (See
page 40.)
Adding mapping information manually (manual
mapping)
During mapping, you can manually add the mapping information with the app. It is
recommended when mapping an intricate floor layout.
1. Tap on [Pause] and then to display remote control buttons.
2. Move the robotic cleaner to trace the floor layout using the remote control
buttons of the app or the remote controller.
• After manually adding the mapping information, tap on
automatic mapping.
• If you want to quit mapping, tap on [x] and then [Go to Home] or press the
start point button on the remote controller.

Changing the name of mapping information

On the [Area Settings] screen, tap on the mapping information you want to
change.
You can tap on a name to go to the settings screen.
1. On the [Area Settings] screen, tap on the mapping information you want to
change.
2. Tap on [Edit Area Name].
3. Edit the name (Up to 8 characters).
39 ENGLISH
to resume