Indication Panel - Makita DVC560 Instruction Manual

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.

Indication panel

► Fig.15: 1. Operating mode 2. Excess level of dust
3. Brushroll error 4. Remaining battery
capacity 5. Battery check / LED lamp button
Operating mode
To change the operating mode, refer to the section for
switch action.
Excess level of dust
If this indicator lights up, replace the filter bag. (Refer
the section of removing the filter bag.)
NOTE: This indicator does not work when the appli-
ance operates in "lower noise level (1)" mode.
NOTE: This indicator may not work depending on the
usage environment.
NOTE: The indicator automatically goes out approxi-
mately one minute after the appliance is switched off.
If you clear the clogging of the filter bag and restart
the appliance, the indicator goes out even within one
minute.
Brushroll error
Blinking
On
WARNING:
Immediately switch off the appli-
ance when this lamp lights up during operation.
Otherwise the motor malfunction may occur and
cause fire.
Remaining
capacity
Blinking
The battery
may have
malfunctioned.
The brushroll is under high
load for some reasons.
The brushroll is stopped by
abnormal reason.
Remaining battery capacity
During operation, press the battery check / LED lamp
button to indicate the remaining battery capacities. The
battery indicators correspond to each battery.
► Fig.16
Battery indicator status
On
Battery check / LED lamp button
During operation, the following operations can be
performed.
• Simply press the button to check the remaining
battery capacity.
• Press and hold the button to turn on / off the LED
lamp.
Switch action
► Fig.17: 1. ON / mode change button 2. OFF button
Turning on / off the appliance
To start the appliance, simply push the ON / mode
change button. To switch off, push the OFF button.
CAUTION:
Always put the head of the appli-
ance on the floor when turning on the appliance.
Otherwise an accident due to entanglement may
occur and cause a personal injury.
Changing operating mode
You can change the operating mode in three steps:
"lower noise level (1)", "normal (2)", and "high (3)".
If you want to change operating mode, press the ON
/ mode change button when the appliance is running.
The operating mode switches in order "lower noise level
(1)" , "normal (2)" , and "high (3)".
The appliance will start in the same mode as the previ-
ous setting.
14 ENGLISH
Off
Blinking
Remaining
battery
capacity
50% to 100%
20% to 50%
0% to 20%
Charge the
battery