Section 4: Operations; Operation Overview - Grizzly T32338 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injury hazard! Always
wear safety glasses when
using this machine.
Do not touch compressor
head or discharge line
during use or immediately
after compressor is active.
These hot parts may cause
burns.
To complete a typical operation, the operator
does the following:
1. Puts on safety glasses.
2. Pulls safety valve ring to test valve and clear
any obstructions.
Model T32338 (Mfd. Since 12/20)
manual BEFORE
3.
Turns regulator knob all the way counter-
clockwise.
4.
Puts on any additional personal protective
equipment required by operation and attach-
ment tool.
5. Connects machine to power and turns it ON.
6.
Allows machine to run until cut-out pressure
has been reached and tanks are full.
7.
Turns regulator knob clockwise until line
pressure gauge displays pressure lower than
or equal to air tool rating.
8.
Connects air hose to quick-connect coupler.
9.
Connects attachment air tool to air hose.
10. While being careful not to create a tripping
hazard with hose, performs operation.
11. Turns machine OFF and disconnects it from
power.
12. Uses safety relief valve to reduce tank pres-
sure to less than 10 PSI.
13. Disconnects attachment tool from hose.
14. Disconnects hose from compressor.
15. Opens drain valve to drain any condensation
from tanks.
16. Closes drain valve.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-17-