Table of Contents
Advertisement
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The compressor oil level is sufficient, 2) the
motor powers up and runs correctly, 3) the motor
and pump turn OFF when the cut-out pressure
is reached, and 4) the safety relief valve works
correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Eye injury hazard! Always
wear safety glasses when
handling pressurized air
system.
To test run machine:
1.
Check oil level (refer to Lubrication on Page
25 for instructions).
Model T32338 (Mfd. Since 12/20)
2.
Clear all setup tools away from machine.
3.
Locate machine in well-ventilated area at
least 18 inches from nearest wall or any
obstructions.
4.
Move pressure switch lever to OFF position
(see Figure 11).
Figure 11. Location of pressure switch lever.
5.
Turn drain valve handle all the way counter-
clockwise to open (see Figure 12).
Figure 12. Drain valve handle in open position.
6.
Connect machine to power supply.
7.
Move pressure switch lever to ON position to
turn machine ON and verify motor operation.
Motor should run smoothly and without
unusual problems or noises.
Pressure
Switch
Lever
Drain Valve
Handle
-15-
Advertisement
Table of Contents
