Checking For Leaks - Grizzly T32338 Owner's Manual

Checking for Leaks

Air leaks will cause low air output and increase
the time the compressor must run.
Checking for Leaks
1. Disconnect tool and hose from compressor.
2. Turn ON compressor and allow tanks to fill
until cut-out pressure is reached (125 PSI).
3.
DISCONNECT MACHINE FROM POWER!
4.
Listen for sound of air to find possible leak.
— If you do not hear air escaping, and pres-
sure in tanks does not change, there is no
leak.
— If you do hear air escaping, or pressure in
tanks drops even with safety relief valve
and drain valve closed, proceed to Step 5.
5.
Spray suspected air leak with soap and water
solution and look for air bubbles.
— If bubbles do not form, repeat at different
location.
— If bubbles do form, proceed to Fixing
Leaks.
Model T32338 (Mfd. Since 12/20)
Fixing Leaks
Item Needed
Wire Brush ......................................................... 1
Thread Sealing Tape or Pipe Dope ... As Needed
To fix leaks:
1. DISCONNECT MACHINE FROM POWER!
Releasing air through safety relief valve
can be extremely loud. Protect hearing with
ANSI-approved hearing protection while
performing following step.
2. Use safety relief valve to reduce tank pres-
sure to less than 10 PSI.
3. Open drain valve to relieve any remaining air.
4. Remove fitting or valve that is leaking.
5. Clean threads, apply thread sealing tape or
pipe dope to threads, then re-install part.
Note: If a fitting or valve continues to leak
after preceding steps, replace part.
Qty
-27-