Table of Contents
Advertisement
Changing Oil
Items Needed
Drain Pan ........................................................... 1
Wrench or Socket 10mm ................................... 1
Wire Brush ......................................................... 1
Teflon Tape ........................................ As Needed
Model T28041 (or SAE 30 Equiv.) ............... 1 Qt.
To change oil:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove oil fill plug (see Figure 35).
3.
Place drain pan under oil drain plug, then
remove oil drain plug (see Figure 35).
Figure 35. Location of oil fill and oil drain plugs.
4.
Clean drain plug threads.
5.
When oil is fully drained, wrap drain plug
threads with Teflon tape, then install drain
plug.
6.
Add oil to compressor until oil level is between
bottom and top of red circle on oil sight glass
(see Figure 34 on Page 25), then install fill
plug.
Note: There is also a dipstick connected to oil
fill plug. Oil level should reach between L and
H marks on dipstick.
-26-
Qty
Oil Fill
Plug
Oil Drain Plug
Checking Air Filter
The air filter helps prevent impurities and dust
from entering the compressor and reduces noise.
A dirty filter will result in a less efficient system
and could become a fire hazard.
To check air filter:
1.
DISCONNECT MACHINE FROM POWER!
Releasing air through safety relief valve
can be extremely loud. Protect hearing
with ANSI-approved hearing protection in
following step.
2.
Use safety relief valve to reduce tank pres-
sure to less than 10 PSI.
3.
Remove wing nut shown in Figure 36 to
remove filter cap and access filter.
Cap
Figure 36. Air filter assembly components.
— If filter is fairly clean and there has not
been a drop in efficiency of compressor,
replace cap. No replacement is required.
— If filter is dirty or clogged, or there has
been a drop in efficiency of compressor,
replace cap. Proceed to Step 4.
4.
Replace old filter with new filter element (refer
to Part #11 in Parts beginning on Page 38).
Model T32338 (Mfd. Since 12/20)
Advertisement
Table of Contents
