Table of Contents
Advertisement
Correct combination of the cutting
tool and the protector
CAUTION:
Always use the correct combi-
nation of cutting tool and the protector. A wrong
combination may not protect you from the cutting tool,
flying debris, and stones. It can also affect the bal-
ance of the tool and result in an injury.
Cutting tool
Cutter blade
(2-tooth, 3-tooth, 4-tooth, and
8-tooth blades)
Nylon cutting head
Plastic blade
Chisel blade
Shredder blade
Installing the protector
WARNING:
Never use the tool without the
guard or with the guard improperly installed.
Failure to do so can cause serious personal injury.
NOTE: The type of the protector supplied as the stan-
dard accessory varies depending on the countries.
For cutter blade
Attach the protector to the clamp using bolts.
Protector
► 1 . Clamp 2. Protector
For nylon cutting head / plastic blade
Attach the protector to the clamp using bolts. After that, install
the protector extension. Insert the protector extension to the
protector and then snap the clips on. Make sure that the tabs
on the protector extension fit into the slots on the protector.
► 1 . Protector 2. Clip 3. Protector extension 4. Cutter
To remove the protector extension from the protector,
unclasp the clips by inserting the hex wrench as illustrated.
► 1 . Hex wrench 2. Clip
15 ENGLISH
2
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
1
2
4
5. Slot 6. Tab
1
5
2
3
6
1
2
Advertisement
Table of Contents
