Installing Hook - Makita TL065D Instruction Manual

To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
1
► 1. Driver bit 2. Sleeve
For tool without sleeve to retain the bit
Use only driver bit/socket bit that has inserting portion
shown in the figure. Do not use any other driver bit/
socket bit.
► (1) 8 mm
Use insert bits shown in the figure. To install the bit, just
insert it into the spindle.
1 2
► 1. Insert bit 2. Spindle
NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
2
(1)
Installing or removing socket
Always use the correct size socket for bolts and nuts.
An incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
To install the socket, push it onto the anvil of the tool
until it locks into place. To remove the socket, simply
pull it off.
1
2
► 1. Socket 2. Anvil

Installing hook

Optional accessory
CAUTION:
When installing the hook, tighten the
screw firmly. Failure to do so may cause the breakage
of the tool or personal injury.
1
2
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
8 ENGLISH
1
2
3