Table of Contents
Advertisement
Test safety systems for possible fault before operation
as follows.
1.
Unload staples from the tool and keep the sub
magazine opened.
2.
Install the battery cartridge.
3.
Only pull the switch trigger without touching the
contact element against the material.
4.
Only touch the contact element against the mate-
rial without pulling the switch trigger.
If the tool operates in the case of 3 and 4 above, the
safety systems are faulty. Stop using the tool immedi-
ately and ask your local service center.
Driving staples
WARNING:
Continue to place the contact
element firmly on the material until the staple is
driven completely. Unintentional firing may cause
personal injuries.
1
2
► 1 . Switch trigger 2. Contact element 3. Front part
4. Rear part
You can operate the tool in either way of "single
sequential actuation" or "contact actuation".
Single sequential actuation:
In this mode, you can drive one staple by one sequen-
tial operation.
1.
Place flat the contact element on the material.
2.
Hold both of the front part and the rear part of the
tool firmly against the material.
3.
Pull the switch trigger fully to drive the staples.
4.
Release your finger from the switch trigger before
move the contact element from the material.
Contact actuation:
In this mode, you can drive staples sequentially.
1.
Pull the switch trigger.
2.
With the switch trigger pulled, place flat the con-
tact element on the material to drive the staples.
3.
Move the tool to the next area and place flat the
contact element on the material again.
NOTE: The groove indicates the point that staple is
driven.
4
3
8 ENGLISH
► 1 . Groove
If the head of the staple remains above the workpiece
surface, drive the staple while holding the stapler head
firmly against the workpiece.
NOTE: If the head of the staple still remains above
the workpiece even you hold the stapler head,
the material may not be suitable for the stapler.
Continuing to use the stapler on such material may
result in a damage to the driver of the stapler and/or
stapler jamming.
Anti dry fire mechanism
WARNING:
When loading staples, always
make sure that the battery cartridge is removed
from the stapler. Unintentional firing may cause
personal injuries and property damage.
This tool is equipped with an anti dry fire mechanism.
When the number of remaining staples in the magazine
becomes 5 - 8 pieces, the switch trigger can no longer
be pulled. At this time, insert a new strip of staples in the
magazine. The switch trigger can be pulled again.
1
Advertisement
Table of Contents
