Makita CL003G Instruction Manual page 16

7. Attach the mesh filter back into the cyclone body
aligning the hooks on the mesh filter with the ports on
the suction outlet of the cyclone body. Turn the mesh
filter as shown in the figure until the hooks are locked
with a click. Make sure that the mesh filter is installed
securely.
1 3
Fig.48
► 1. Mesh filter 2. Cyclone body 3. Hook 4. Port
Air channels in cyclone unit
Incoming foreign substance may block the air channels
in the cyclone unit and laden air flows. Remove any
obstacles in the air path if the suction performance is
being affected remarkably.
1. Disassemble the cyclone unit into three compo-
nents: dust case, mesh filter and cyclone body.
1
Fig.49
► 1. Dust case 2. Mesh filter 3. Cyclone body
4. Cleaner body
4
2
2
4
3
2. Press and hold the guide stopper on the inlet pipe
down through the locking hole on the cyclone body
using the hand tool with a point. Then detach the inlet
pipe from the cyclone body.
4
1
Fig.50
► 1. Inlet pipe 2. Guide stopper 3. Cyclone body 4. Locking hole
3. Clean off any substance found in the air channels.
Foreign substance is likely to get stuck around an incoming air port.
Fig.51
► 1. Suction inlet 2. Incoming air port
4. Insert the inlet pipe back in place until it is securely locked.
4
Fig.52
► 1. Inlet pipe 2. Cyclone body 3. O-ring 4. Flap valve
16 ENGLISH
3
1
3
1
2
2
2