Makita UB002C Instruction Manual page 9

NOTICE:
Make sure that the screws on the hose
clamps are facing the direction shown in the
figure.
Fig.5
► 1 . Screw
5.
Clamp the control cable to the cable holders.
2
1
Fig.6
► 1 . Cable holder 2. Control cable
NOTICE:
Make sure that the control cable is
securely fixed to the cable holders.
1
9 ENGLISH
Installing the end nozzle
Align the triangle mark on the end nozzle with that on
the swivel pipe, then attach the end nozzle to the swivel
pipe, and then turn the end nozzle to lock it into place.
Fig.7
► 1 . Triangle mark 2. End nozzle 3. Swivel pipe
To remove the end nozzle, perform the installation
procedure in reverse.
NOTE: The length of the nozzle can be changed by
moving the nozzle as shown in the figure.
1
Fig.8
► 1 . End nozzle 2. Swivel pipe
1
2 3
2