Operation; Maintenance - Makita DFT060T Instruction Manual

OPERATION

Screwdriving operation
CAUTION:
Hold the tool firmly and place the
driver bit/socket bit securely over the screw head/
bolt head during fastening operation. Failure to
do so may cause mishandling of the tool resulting in
personal injury.
CAUTION:
Make sure that the driver bit/
socket bit is placed straight over the screw head,
or the screw and driver bit/socket bit may be
damaged.
CAUTION:
Keep hands away from the rotating
parts during operation. Failure to do so may cause
your hands to be caught in the moving parts, resulting
in personal injury.
Place the tip of the driver bit/socket bit straight over the
screw head/bolt head, apply pressure to the tool, and
then switch the tool on.
The tool automatically stops the motor when the output
torque reaches the target torque set in the application
software. Release the switch trigger after the tool
comes to a complete stop.
Fig.20
Limits of fastening capacity
NOTICE:
Operating temperature range
Use the tool in the recommended ambient tempera-
ture range of 0 °C - 40 °C. Operation outside the
recommended temperature may reduce the tool
performance, resulting in insufficient fastening or
unstable output torque.
Use the tool within the limits of its fastening capacity.
If you use the tool beyond the limits, the output torque
may be reduced as a means of tool protection.
For model DFT060T
360°
300°
240°
2
180°
120°
60°
30°
2.0
1. Range of fastening capacity 2. Rotation angle
3. Torque
For model DFT120T
360°
300°
240°
2
180°
120°
60°
30°
4.0
1. Range of fastening capacity 2. Rotation angle
3. Torque
NOTE: The rotation angle is the angle from the point
that the bolt is tightened in 50% of desired torque to
the point that the bolt is tightened in 100% torque.
NOTE: Use of a cold battery cartridge may give
warning for battery capacity by LED indicator and
beeper and stop the tool immediately, even if it is fully
charged. In this case, the fastening capacity may be
inferior to the specification on this manual.

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
16 ENGLISH
1
3.0 4.0 5.0
3
N•m
1
6.0 10.0
8.0
3
N•m
6.0
12.0