Makita EB5300TH Original Instruction Manual page 21

Throttle valve
Control cable
If the throttle valve does not touch the throttle
valve stopper even you pull the throttle trigger
fully or if the throttle valve does not touch the
idling adjusting screw while idling, turn the cable
If the throttle valve does not touch the throt-
tle valve stopper, turn the cable adjusting bolt
counterclockwise.
If the throttle valve does not touch the idling adjust-
ing screw, turn the cable adjusting bolt clockwise.
1
Cable adjusting bolt
adjusting bolt.
Check the movement of the throttle valve. The
throttle valve comes to the position as illustrated
when the throttle trigger/lever is pulled/turned.
1
4 3 2
Idling adjusting screw
Throttle valve stopper
2
Fixing nut
to check the throttle valve, clean the carburetor
NOTICE:
tarnished.
Pass a slotted screwdriver through the hole
on the engine cover. Release the clamp of the
carburetor cover.
1
Carburetor cover
Clean the carburetor cover.
NOTICE:
Return the carburetor cover. Make sure the
clamp of the carburetor cover clicks when it is
set in place.
21 ENGLISH
Otherwise it may be