Makita EB5300TH Original Instruction Manual page 14

NOTICE:
NOTICE:
Otherwise released starter
knob may hit your body or it may not rewind
appropriately.
NOTE:
When the engine starts, down the choke
lever to open position.
NOTE: Open the choke lever fully before pull-
ing the throttle.
NOTE: In cold temperature or when the engine
is not warm enough, never open the choke
lever suddenly. Otherwise, the engine may
stop.
Warm-up for 2 to 3 minutes with engine
speed idle or low.
Warm-up is complete when quick engine
acceleration from low rpm to full throttle is felt.
NOTE:
fuel, remove the spark plug and pull the handle
several times rapidly to discharge any excess
fuel. Dry the spark plug electrode.
CAUTION:
Push the primer pump several times.
Make sure that the choke lever is open.
Put your left hand on the top of the blower
and pull the starter handle slowly with your right
hand untill you feel the compression. Then pull
the starter handle strongly.
position.
2
1
Throttle trigger
to the low speed position to reduce the engine
Throttle lever
NOTICE:
Otherwise the engine may be damaged by
overheating.
When the environmental temperature is low and
humidity is high, water vapor may freeze inside
the carburetor and the engine drives unsteadily
(carburetor icing). Change the setting of the anti
icing lever as follows if necessary.
Remove the screw and pull out the anti-ic-
ing lever.
14 ENGLISH
Release the throttle
Stop control lever
Set the throttle lever
1
2
Stop switch