Rebooting Versus Resetting A Dome; Rebooting The Dome; Resetting The Dome - GE IDP-1111 User Manual

To call up presets using a GE KTD-405 keypad:
1. Press the find key on the keypad.
2. Press the number keys for the desired preset number. You can either:
• Press the preceding zeros and the number. For instance, if you have more than a 100 domes in your
system, press 0, 0, and 7 for camera number 7.
• Press the number without the preceeding zeros and also press the set (
press 7 and set (
To create presets, see Presets page
To use the KTD-405 keypad, see KTD-405 Controller Keypad User Manual (1036547).

Rebooting versus resetting a dome

Rebooting a dome requires that you have valid communication between the keypad and the dome. You can
reset a dome with or without valid communication between the keypad and dome.

Rebooting the dome

You cannot currently reboot Legend domes from other keypads.
To reboot a dome, do the following from the KTD-405 keypad:
1. At the normal display (CAMERA #/MONITOR #), press and hold the set (
until you hear a beep and the programming code display appears on the keypad's LCD.
2. At the ENTER PROGRAMMING CODE: display, enter the reset access code by pressing the 1, 4, 7, 6,
and seq keys.
3. At the RESET TO DEFAULTS? display, press iris + for yes.
4. At the display that asks what to reset, press 3 to select CAMERA.
5. At the RESET CAMERA #? ARE YOU SURE? display, press iris + to select yes.
The camera reboots in about 60 seconds. You will see the RESETTING CAMERA # display on the
keypad LCD and the color bars and splash screen on the monitor screen as the camera reinitializes itself.

Resetting the dome

You can reset the dome whether or not you have valid communication between the keypad and the dome.
To reset the dome, cycle the power to the dome by turning the power off then on.
).
on page 42.
Chapter 6
System operation
) key. For instance,
) key on the keypad
81