Using The Graphical Keyboard; Inactivity Timer - GE IDP-1111 User Manual

Using the graphical keyboard

The programming interface has an internal graphical keyboard for entering passcodes, network data, and
custom titles. Open the graphical keyboard (Figure 9) by selecting the icon
necessary characters, select Done on the keyboard or press the set (
page. Then select OK to save the changes made to the page. Pressing esc on the keypad while you are still in
the keyboard erases the characters shown. You must select OK or Cancel to save or cancel the changes entered
on the page.
Figure 9. Using the keyboard of the programming interface

Inactivity timer

The programming interface has a 10-minute keypad inactivity timer. When being used with keypads that do
not have their own inactivity timer, the programming interface will time out after 10 minutes of inactivity.
When being used with keypads that do have their own inactivity timer and it is less than the 10-minute timer of
the programming interface, the programming interface will time out when the keypad does. When being used
with keypads that have a longer inactivity timer, the programming interface will time out after 10 minutes of
inactivity. Refer to your keypad's manual to see if it has an inactivity timer and what the duration is so that you
know when you can expect the programming interface to time out.
3 Select the OK icon to save
changes to the page.
Programming tools
1 . After you have entered the
) key on the keypad to return to the
1 Select the ab icon to
open the keyboard.
2 2 Select the Done icon to Select the Done icon to
close the keyboard. close the keyboard.
Chapter 3 13