Shadowtours - GE IDP-1111 User Manual

18 Legend
User Manual

ShadowTours

You have a total of 16 ShadowTours (totaling 20 minutes) that you can define for the dome. A ShadowTour is
a tour that the camera learns by recording your manual operation of the camera. Use a keypad to manually
direct the camera through the desired PTZ movements. The camera stores those movements in memory. The
recorded tour can be replayed at any time.
To program ShadowTours with the programming interface, do the following:
1. Access the programming interface. See
a. Press and hold the set (
display appears on the keypad's LCD.
b. Press the 9, 5, 1, and seq keys on the keypad.
c. Press 3 to select CAMERA.
Note:
d. Enter the number for the camera site you are programming.
The programming interface will appear on the monitor screen and you will start using the
joystick to enter commands.
e. If passcodes are turned on, select your passcode level and enter your passcode. If passcodes are
turned off, you will be taken directly to the main programming page.
The programming interface will appear on the monitor screen and you will start using the
joystick to enter commands.
2. Select Actions by guiding the joystick to move the cursor over the Actions menu and twisting the
joystick knob.
Figure 11. ShadowTour programming page
3. Select ShadowTours.
4. Select a ShadowTour number.
5. Select Program.
6. Press and release the set (
7. Use the joystick to manually direct the camera through the desired PTZ movements
) key on the keypad until you hear a beep and the programming code
If you have an older keypad, the LCD will say CYBERDOME, instead of CAMERA, and you will have an
additional self-explanatory screen to step through.
) key on the keypad to start the ShadowTour timer.
Accessing the programming interface on page 7.