Replace Dc Power Module - Cisco 8800 Series Hardware Installation Manual

Replace DC Power Module

Figure 92: Power Supply Bezel for 8804 Chassis
Replace DC Power Module
Follow these steps to remove a DC power module from the chassis.
Procedure
Step 1 Pull the handle down.
Step 2
Unscrew the screw that secures the power module using a Phillips screw driver.
Step 3 Slide the power module out of its bay while supporting it with your other hand to remove it.
Figure 93: DC Power Module
Step 4
Slide the new power module into the bay until it mates with its backplane connector.
Hardware Installation Guide for Cisco 8800 Series Routers
128
Replace Chassis Components