Verify Chassis Installation - Cisco 8800 Series Hardware Installation Manual

Verify Chassis Installation

When you enter the same password, the software accepts the password.
Step 5
Enter the configuration mode.
Step 6 Enter the IP address for the management interface. If using dual RPs, enter the IP address on both management
interfaces.
Step 7
Enter a network mask for the management interface.
Step 8 The software asks whether you want to edit the configuration. Enter 'no' to decline.
Verify Chassis Installation
After installing the chassis, use the following show commands to verify the installation and configuration in
the EXEC mode. Any issue if detected, take corrective action before making further configurations.
Command Description
show platform Displays the state information of each card.
show redundancy Displays the status of route processor redundancy.
show led Displays LED information for the router, or for a specific LED location.
show hw-module fpd Displays field-programmable device (FPD) compatibility for all modules or a specific module.
show alarms brief system Displays all existing alarms in the router.
active
show media Displays the current state of the disk storage media.
show inventory Displays information about the field replaceable units (FRUs), including product IDs, serial numbers,
and version IDs.
show environment Displays all the environment-related router information.
Hardware Installation Guide for Cisco 8800 Series Routers
88
Connect Router to the Network