Table of Contents
Advertisement
5.3.5 Accessing the statistics in the Data menu
5.3.6 Checking Fault messages
5.4 Advanced settings (for installers only)
5.4. 1 Setting of battery parameters
5.4.2 Setting of grid parameters
Charging and Discharging settings of the AEG energy
storage system
5.4.3 Additional settings
6. TROUBLESHOOTING
6. 1 Battery pack warnings and troubleshooting
6.2 Energy storage system warnings and
troubleshooting
6.2. 1 Fault codes
6.2.2 Troubleshooting specific faults
7. GENERATOR AND AC COUPLING FUNCTION
8. PRODUCT END OF LIFE
9. DISCLAIMER OF LIABILITY
10. CONTACT
1. PRELIMINARY REMARKS
1.1 Icons
This section describes relevant warning symbols
recurring in the installation and operation manual of
AEG energy storage systems. Icons highlight relevant
information for the physical and property safety of
the user. Compliance to the provided instructions
is essential to prevent physical injury and product
damage. Below is a list of the icons used in this manual:
Icon
Meaning
Instruction
Danger
Serious physical injury or
even death may occur in case
of noncompliance with the
requirement (electrical hazard)
Warning
Physical injury or product
damage may occur in case of
noncompliance with the
requirement.
Electro-
Damage may occur in case of
static
noncompliance with the
discharge
requirement.
Hot
Product surface may become
surface
hot, do not touch
Note
Useful information for product
i
maintenance and operation is
provided
Table 1: Icon meaning
AEG LOW VOLTAGE ENERGY STORAGE UNIT (8 KWH / 12 KWH) INSTALLATION MANUAL
1.2 Product Identification
25
25
Energy Storage System:
26
Each energy storage system can be identified by means
26
of the following information:
26
Serial Number
27
Each storage unit is identified by a unique serial
27
number univocally coupled with a barcode, to be found
27
on the cabinet.
27
Product Label
28
The product label of the energy storage unit is placed
28
on the housing. It provides information about the main
29
parameters of the storage unit such as: Product Name
30
Code (PNC), Capacity, PV Input, AC Grid Port Input and
30
Output, Off-Grid AC Output, Battery Data, and further
31
operation parameters.
31
AEG
Solar Solutions GmbH
is a registered trademark
Brückenstrasse 94
used under license
60594 Frankfurt am Main
from AB Electrolux (publ).
Germany
HOME ENERGY STORAGE SYSTEM
MODEL (PNC): AS-BSL1-8000
CAPACITY
Nominal storage capacity (kWh)
Usable storage capacity (kWh)
PV INPUT
Max. recommended DC power (W)
Max. DC voltage (V)
MPPT voltage range (V)
Max. input current (A)
Max. short current (A)
Number of MPPT trackers
AC GRID PORT INPUT AND OUTPUT
Grid type
Single phase (L/N/PE)
AC voltage (V
)
Max. continuous power (W)
Max. AC apparent power (VA)
Max. AC output current (A)
Max. AC intput current (A)
Grid frequency/range (Hz)
Power factor range
OFF-GRID AC OUTPUT
Grid type
Single phase (L/N/PE)
AC voltage (V
)
Max. continuous power (W)
Max. AC apparent power (VA)
Max. AC output current (A)
Grid frequency/range (Hz)
Power factor range
BATTERY DATA
Battery type
Lithium (LFP)
Normal voltage (V)
Voltage range (V)
Max. charge/discharge current (A)
REGULAR PARAMETERS
Protective class
Ingress protection
Overvoltage category
OVC II(PV) OVCIII(AC)
Inverter topology
Non-isolated
Operating temperature range (°C)
10 min
Energy storage system label example
AS-BSL1-8000
Icon
Meaning
Safety warning: electrical hazard
Wait at least 10 minutes after
disconnecting the inverter before
10min
touching internal parts
Product surface may become hot, do not
touch
+49 69 800 500 810
AEG
info@aeg-industrialsolar.de
is a registered trademark
www.aeg-industrialsolar.de
used under license
Product assembled in the P.R.C.
from AB Electrolux (publ).
HOME ENERGY STORAGE SYSTEM
MODEL (PNC): AS-BSL1-12000
CAPACITY
7.68
Nominal storage capacity (kWh)
Usable storage capacity (kWh)
6. 1 4
PV INPUT
6500
Max. recommended DC power (W)
Max. DC voltage (V)
500
125-425
MPPT voltage range (V)
11/11
Max. input current (A)
Max. short current (A)
16/16
2
Number of MPPT trackers
AC GRID PORT INPUT AND OUTPUT
Grid type
230
AC voltage (V
)
5000
Max. continuous power (W)
Max. AC apparent power (VA)
5000
25
Max. AC output current (A)
25
Max. AC intput current (A)
Grid frequency/range (Hz)
50
-0.8～+0.8
Power factor range
OFF-GRID AC OUTPUT
Grid type
230
AC voltage (V
)
5000
Max. continuous power (W)
Max. AC apparent power (VA)
5000
25
Max. AC output current (A)
50
Grid frequency/range (Hz)
Power factor range
-0.8～+0.8
BATTERY DATA
Battery type
Normal voltage (V)
51.2
42~58
Voltage range (V)
100
Max. charge/discharge current (A)
REGULAR PARAMETERS
Class I
Protective class
IP 20
Ingress protection
Overvoltage category
Inverter topology
Operating temperature range (°C)
-10～+40
10 min
AS-BSL1-12000
EN
PD202107 V1-21
3
Solar Solutions GmbH
+49 69 800 500 810
Brückenstrasse 94
info@aeg-industrialsolar.de
60594 Frankfurt am Main
www.aeg-industrialsolar.de
Germany
Product assembled in the P.R.C.
11.52
9.22
6500
500
125-425
11/11
16/16
2
Single phase (L/N/PE)
230
5000
5000
25
25
50
-0.8 ~+0.8
Single phase (L/N/PE)
230
5000
5000
25
50
-0.8 ~+0.8
Lithium (LFP)
51.2
42~58
100
Class I
IP 20
OVC II(PV) OVCIII(AC)
Non-isolated
-10～+40
Advertisement
Table of Contents
