Table of Contents
Advertisement
Charging and Discharging settings of the AEG
energy storage system
Note:
•
If the option „House Load Only" in the „Energy
Utilization" setting was chosen, do not tick „Grid
sell"
•
If the option „House Load Only & grid feed-in" in
the „Energy Utilization" setting was chosen, please
tick „Grid sell"
•
Six periods can be set from 0:00 to 24:00
•
Grid sell: the energy generated by the photovoltaic
system powers the house loads and battery as
priority; excess energy is sold back to the grid
•
Limited Power to Load: check this box if the
output power depends on the actual loads
•
Limited Power to Home: check this box if the
output power depends on the CT position.
5.4.3 Additional settings
Additional information is accessible to the installer,
such as the version of inverter hardware and software.
AEG LOW VOLTAGE ENERGY STORAGE UNIT (8 KWH / 12 KWH) INSTALLATION MANUAL
Solar Arc Fault on: this option is only available for the
US market.
6. TROUBLESHOOTING
6.1 Battery pack warnings and troubleshooting
Check the indicators on the front to determine the
state of the battery pack. A warning state is triggered
when a condition, such as with voltage or current or
temperature, reaches beyond design limitations.
The battery pack's BMS periodically reports its
operating state to the inverter. When the battery pack
parameters reach beyond the prescribed limits, the
battery pack enters a warning state. When a warning is
reported, the inverter immediately ceases to operate.
The warning messages are shown in the display of the
storage system.
The possible warning messages are::
•
Battery Over Voltage
•
Battery Under Voltage
•
Battery Over Temperature
•
Battery Under Temperature
•
Battery Discharge Over Current
•
Battery Charge Over Current
The abnormal state is cleared when the battery pack
recovers normal operation.
27
EN
PD202107 V1-21
Advertisement
Table of Contents
