Makita M5802 Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Base
ASSEMBLING
(1) Assemble Base by taking reverse step of Disassembling. Refer to Fig. 4, Fig. 3, Fig. 2.
< Note >
Pay attention to the matters in Fig. 5, when assembling Base.
1. Do not forget to mount Spring washer 5,
when assembling on Angular plate side.
M5 Pan
head screw
Spring washer 5
M5 Hex nut
[3] -2-a Armature
DISASSEMBLING
(1) Take out Armature as shown in Fig. 6.
1. First , remove Brush holder cap and
Carbon brush. And unscrew M5x40
Pan head screw.
Carbon brush
Brush
holder cap
2. Remove Motor housing
Motor housing
complete
M5x40 Pan head
screw ( 3 pcs.)
Carbon brush
Brush
holder cap
< Note >
Be careful, not to lose Flat washer 14, and O ring 18,
when separating Motor housing.
Fig.5
2. Bow stop ring E-12 has to be mounted as shown in
the illustration below.
So, Bow stop ring E-12 can transmit the pressure
force from M8-13 Hex nut.
Fig.6
complete.
O Ring 18
Flat washer 14
M8x24 Flat
headsquare neck bolt
M8-13 Hex nut
Lever plate
Bow stop ring E-12
3. Pull off Armature assembly
from Gear room of Blade case.
Armature
P 5 / 12