Makita M5802 Technical Information page 3

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Base
DISASSEMBLING
(1) Remove saw blade in accordance with the instruction manual. First, remove M8x24 Flat headsquare
neck bolt on Depth guide side, as shown in Fig. 2.
Angular plate
Angular plate side
1. Loosen M8-13 Hex nut, by turning Lever plate.
See the illustration below.
3. Remove M8-13 Hex nut, and then, remove Flat washer 8.
Consequently, M8x24 Flat headsquare neck bolt may fall
onto reverse side of Safety cover.
See the illustration bellow.
Safety cover
Lever plate
M8-13 Hex nut
M8-13
Lever plate
Hex nut
Flat washer 8
M8x24 Flat headsquare neck bolt
may fall onto reverse side of
Safety cover.
Depth guide
Depth guide side
Fig. 2
2. Remove Bow stop ring E-12 by turning
it with slotted head screwdriver.
See the photograph below.
Bow stop ring E-12
4. Remove Rubber sleeve 6, unscrewing
one M6x20 Pan head screw.
Rubber sleeve 6
M6x20 Pan head screw
5. Now Safety cover swing toward Angular
plate side. And M8x24 Flat headsquare
neck bolt can be removed.
Now, Base section is free from the
machine on the depth guide side.
M8x24 Flat
headsquare
neck bolt
P 3 / 12
Slotted head
screwdriver