Cleaner Body; Sponge Filter - Makita DCL181F Instruction Manual

Cleaner body

From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening and filter mounting
area.
Filter
Wash the filter in soapy water when it is clogged with
dust and the cleaner power becomes weak. Dry it out
thoroughly before use.

Sponge filter

When the sponge filter becomes dirty, clean it as
follows.
1. Remove the filter.
2. Pull out the sponge filter from between the pillars.
3. Clean the sponge filter by tapping or washing. If
you wash it, dry it out thoroughly before use.
4. Insert the sponge filter from between the pillars and
set it in the original position. Make sure that each bottom
edge of the pillar holds down the sponge filter, and there is
no gap between the sponge filter and suction opening.
► 1. Sponge filter 2. Bottom edge of pillar
Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw
into.
Attach the wall mount for cordless cleaner to a hard wooden wall,
beam or column, where the wall mount for cordless cleaner can
be firmly secured. Always be sure that the wall mount for cordless
cleaner is securely attached before hanging the cleaner.
1
► 1. Wall mount for cordless cleaner
CAUTION:
Do not hang the cleaner to the wall
mount violently or hang other appliances than the
cleaner.
12 ENGLISH
1
2