Time Based Grinding Operation - Baratza SETTE 270 Manual

TIME BASED GRINDING OPERATION

Place the portafilter, grounds bin or other brewing devices on to
the convertible device arms. Press a preset button (1,2,3). The
screen will show the corresponding programmed grind time in
seconds. Press START button to begin grinding. While grinding,
the screen will count up the seconds to the target time, the green
light will be illuminated, then the motor will stop and the display
will reset again to the programmed time.
If you would like to stop before the cycle has completed, press
the STOP button. This will turn the motor off, and reset the screen
to your initially chosen grind time. However, if you would like to pause the grind without resetting to the initially chosen
grind time, press the PAUSE button. This will immediately pause the machine, and the screen will flash the elapsed time. By
pressing START it will continue grinding towards the desired time. To reset the grind cycle press the STOP button.
PULSE FUNCTION
The Sette 270 also has a pulse function/manual time grinding mode. To turn the grinder on in this mode, simply hold the
START button for more than 2 seconds, the display will flash "- - -" and grinding will commence. You are now in pulse mode.
The motor will continue to run as long as your finger is on the START button and will turn off when you remove your finger. To
Exit this mode press STOP
PROGRAMMING
The Sette is equipped with three programmable preset buttons. The buttons are simply labeled 1,2,3. These programmable
buttons only adjust the amount of time for coffee to be ground, they do not adjust the grind setting. Each button comes from
the factory with the following presets: Time: 1=10s, 2=20s, 3=30s.
You can easily program more or less grinding time as follows:
1. Select a Preset button.
2. Press the grind time adjustment buttons to adjust the seconds up or down as small as a hundredth of a
second. If you press and hold the up or down arrow for two seconds, the numbers will speed up.
3. Once you have reached the desired time setting, press and hold the preset button for three seconds.
The setting will blink to confirm the setting is stored.
4. To program the other buttons repeat steps 1-3. If the grinder is unplugged it will retain the stored settings.
SETTE™ 270 MANUAL
8
v2.1 August 27, 2019