Attaching The Shoulder Belt - Makita DCL500Z Instruction Manual

Insert the zoom pipe into the end of the
handle.
1
2
Loosen the zoom pipe ring and adjust the
pipe length. After adjustment, tighten the
ring.
1
Attach the nozzle to the zoom pipe.
Attach the crevice nozzle to the handle or
zoom pipe to use to clean crevices and other
narrow, hard-to-reach areas.
1
CAUTION:
• Do not cover the hole of the crevice
nozzle. It may cause overheat and result in
damage to the appliance.
6
1. Handle
2. Zoom pipe
1. Ring
1. Nozzle
1
1. Crevice nozzle

Attaching the shoulder belt

CAUTION:
• When hanging the appliance on your
shoulder, always hold the appliance itself
by hand to prevent it from dropping.
Dropping the appliance may cause injury
or property damage.
Use the shoulder belt to hang the appliance
on your shoulder for cleaning a high place.
Loop the shoulder belt around both the
carrying handle and the belt holder and then
run it through the stopper as shown in the
diagram.
Pull the ends of the belt up so that they are at
least 80 mm (3") from the top of the stopper.
1. Shoulder belt
1