Installing Dust Bag; Installing The Shoulder Strap; Connecting The Hose - Makita DVC350F Instruction Manual

Installing dust bag

2
1
3
1. Dust outlet
2. Dust bag joint
3. Pins
4. Dust bag
011113
Hold the square section of the dust bag joint and fit the
pins inside the dust bag joint to the notches in the dust
outlet of the cleaner and then insert and turn it clockwise
all the way until it stops.
011114
At this time, make sure that the fastener part on the dust
bag faces upward.
NOTE:
When the dust bag joint and the ring inside the
•
dust bag come off, install as follows.
(1) Align the dust bag joint with the seam of the
dust bag and install it so that its protrusion
faces upward.
011115
(2) Tighten the ring inside the dust bag firmly so
that the pins and the ring are positioned as
shown in the figure.
4
1. Hook
1
1. Protrusion
1
1
011116

Installing the shoulder strap

1
011117
Attach one end hook of the shoulder strap onto the ring
in the front of the cleaner and thrust the other end of the
strap through the band of the dust bag and then attach
the other end hook as shown in the figure.
Adjusting the shoulder strap
1
3
011118
To adjust the length of the shoulder strap, pull it out to
your desired length and pull the strap in the direction of
arrow as shown in the figure.

Connecting the hose

CAUTION:
Do not force the hose to bend it and/or stamp it.
•
Forcing and/or stamping the hose may cause
deformation or damage to the hose.
5
1. Pins
2
2. Ring
1. Shoulder strap
2. Two hooks
2
1. Pull out
2. For shortening
3. For extending
2