Honeywell NOTIFIER AM-8000 Programming Manual page 48

 Modify Status - Detectors
The display shows by default the first device of the first line. To select another device use the function keys.
 Modify Status - Modules
The display shows by default the first device of the first line. To select another device use the function keys.
 Modify Status - Zones
The display shows by default the first zone. To select another zone use the function keys
Pag. 44
NOTIFIER ITALIA
Programming Manual
Doc. M-160.2-AM-8000-ENG Rev A1
When a detector is Disabled the control unit
is inhibited to the reception of the Alarm and
Faults signaling from the sensor.
To Disable a detector select it through the
function keys. Once the device has been
selected press the enter key
the arrow keys select YES and
subsequently press the enter key
confirm the disablement.
When a module is Disabled the control unit is
inhibited to the reception of the Alarm and
Faults signaling from the module.
To Disable a module select it through the
function keys. Once the device has been
selected press the enter key
the arrow keys select YES and
subsequently press the enter key
confirm the disablement.
When a Zone is Disabled the control unit is
inhibited to receive the Alarm and Fault
signaling from all the points which belong to
the Zone.
To Disable a zone select it through the
function keys. Once the zone has been
selected press the enter key
the Arrow keys  select
subsequently press the enter
confirm the Disablement.
AM8000_manu-prog-ENG
and through
to
and through
to
and through
"YES" and
key to
SERIEAM