Displays - Casio SA-400 Owner's Manual

ADDITIONAL INFORMATION

DISPLAYS

DISPLAYED MESSAGE
Tried to access a line when all
lines were in use.
This caller blocked their caller
ID record.
Station has joined a
conference call.
Station is transferring a call.
was pressed and
CALLER ID
there are no records.
The displays prompts you to
press the AUTO INTERCOM
key corresponding to the
station number or enter the
station number of the unit you
want to transfer a call to or
intercom.
The incorrect data was
entered during time and date
setup.
Station has initiated an
intercom call.
Your station ID or a non-
existing station was entered.
The LOWER button on the
autodial bank has been
pressed.
Caller ID record received, but
included unrecognizable data.
STATUS ACTION
Try a little later.
See "CALL WAITING CALLER
ID SERVICE OPTIONS" on
page 21.
See page 36.
See page 34.
You may not subscribe to
caller ID. See "PROGRAM-
MING CALL WAITING CALLER
ID" section on pages 21-22.
Press an AUTO INTERCOM
key or use the keypad to enter
two-digit ID of the station you
want to transfer a call to or
intercom.
Re-enter the correct time and
date. See page 12 under
"SETTING THE TIME AND
DATE."
See pages 37-38.
Enter the correct station ID.
See "INTERCOM & PAGING
OPERATION" on page 37.
When " " appears on
the display press an autodial
station to access lower
autodial stations. See
"PROGRAMMING AUTODIAL"
on pages 17-19.
44
ADDITIONAL INFORMATION
DISPLAYS
DISPLAYED MESSAGE
Nothing stored in this autodial
location.
Sending a page.
Line 1 has been disconnected
and then reconnected, a
station has been added to the
system, the AC power has
been removed and then
reconnected, a power failure
occurred or a unit changed it's
station ID.
Line 1 has been disconnected.
Station has released privacy.
Station has restored privacy.
The scratch pad button has
been pressed.
Line 1 has been disconnected,
AC power was lost or this is
initial setup.
Can not intercom, page all or
transfer.
(cont.)
STATUS ACTION
Select another autodial
location or store an autodial
number. See pages 17-19,
under "PROGRAMMING
AUTODIAL."
See page 39 to send a page.
Perform a system update at
another station. See page 43
under "PERFORMING A
SYSTEM UPDATE."
Reconnect line 1. If display
still appears after the line is
reconnected, make sure line 1
is not in use when line 1 is
reconnected.
Privacy has been released on
this call.
Privacy has been restored on
this call.
Enter the number you want to
store and then press
again. See page 31.
Press the soft key under
" ." See page 12 under
"ASSIGNING A STATION
EXTENSION NUMBER."
The intended station is busy
or other stations may be using
the intercom or page
functions. Try again later. See
"INTERCOM & PAGING
OPERATION" on pages 37-39.
45
SCRATCH PAD